Cinegrez

Replace the drum [E] White clip x1 [F]. The total rotation time is 30 seconds. Continue to rotate the black gear until the developer is level. I will warn you that it will most likely get messy. Remove the development roller [H] from the development unit. Turn the development roller gear [I] to remove toner from around the development roller.

Uploader: Doktilar
Date Added: 20 January 2007
File Size: 63.11 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 13766
Price: Free* [*Free Regsitration Required]

Remove the rear cover [B] x3, Coupling x1. Replace the cleaning blade [A] x2 Reinstallation: Remove the rear screws [B] x2.

Press the Reset Yellow key 3. Do not spill developer on the gears or sponges. Make sure that all of the holes and tabs on are engaged at [A], [B], and [C].

Replace the drum [E] White clip x1 [F].

While continuing to turn the black gear, slowly move the pack left and right and pour the remaining half of the developer over the augur until the developer is level. Then push down to lock the tabs on the gesteter and rear end of the PCU. The drum unit is photo conductive. Photoconductor Unit PCU 1. Set the bottom on the vinyl sheet.

  DVB T2100 CARDBUS DRIVER

DSm725/730

Remove the PCU from the machine. Continue to rotate the black gear until the developer is level. Before you get stressed out by looking at the long list of directions below, look at the illustration in the middle of the page.

Open the developer pack [J] Remove the front screw [A] x1 5. Tighten the lower screw [E]. Follow the cautions below when handling a PCU.

Spread the vinyl sheet provided with the developer kit on a flat surface. On the number pad enter 1 0 7 4.

Gestetner DSm Toner Cartridge

If left in the light for a long period of time it will get damaged. Replace the cleaning roller [F]. Turn on the main power switch, and close the front door. Set the rear cover and front cover [B].

Gestetner DSm730 Consumables

Remove the front cover [A] x2. If the holes are not aligned correctly, make sure that the tabs at the front, rear, and left side of the PCU are engaged correctly. The total rotation time is 30 seconds. Remove the top part [C] x1.

  786B2 BIOS DRIVER

Therefore, I would recommend cleaning off a desk or work area ahead of time, organize your partsthen remove the PCU unit and take it over to the area where you will be working.

Open and close the door two more times.

While turning the black gear [K], slowly move the pack left and right and pour half of the developer over the auger [L]. Attach the side screw [G]. Press and Hold the C key. Replace the charge roller [E]. 70 the development roller gear [I] to remove toner from around the development roller.